油研9号氮、钾、硼肥的施用技术

为了探讨油菜良种良法配套栽培技术,以新品种油研9号进行了氮肥的不同施用比例、钾肥的不同施用量、硼肥的不同施用方式的研究。结果表明:在相同施氮量下,以基肥:苗肥:薹肥为3:4:3时产量最高,与5:3:2和6:2:2 的施用比例达显著性差异;与4:3:3的施用比例差异不显著。不同钾肥施用量以底施氯化钾15 kg／667m2产量最高,底施氯化钾均与不施氯化钾达极显著性差异,但底施氯化钾15 kg／667m2比底施氯化钾7．5 kg／667m2增产不显著。不同硼肥的施用方式,以薹施硼肥1 kg／667m2产量最高,薹施(1kg／667m2)、底施(1 kg／667m2)、花喷(100g／667m2)硼肥分别比不施硼肥增产 31．5％、22．8％、5．5％,施用硼肥与不施硼肥均达显著性差异,薹施和底施硼肥增产效果明显,花喷增产效果较差。     

Influence of death struggle on the structural changes in chub mackerel muscle during chilled storage

ABSTRACT: Chub mackerel (34–35 cm, approximately 500 g), which were caught by fishing with a rod and line at the Bungo Channel, Oita prefecture, were rested overnight in a fish preserve and either killed by decapitation (control group) or allowed to struggle in air for 30 min (struggled group). Muscle samples were excised every 4 h, and measurements on breaking strength and histological observations were done for both groups. The breaking strength of muscle in the control group was significantly higher than that in the struggled group, whereby a decrease in breaking strength was delayed for 12 h compared to the struggled group. Light microscopy showed space extension among muscle cells in association with a decrease in breaking strength. Especially in the struggled group, the extended area was larger and the difference in area was significant at the time when breaking strength showed a significant difference. Using electron microscopy, the extended area showed cut and/or disappeared collagen fibrils. From these results, it was demonstrated that struggling to death promoted the degradation of collagen fibrils and the weakening of connective tissue and, resultantly, led to the faster softening of muscle of chub mackerel.     

论建筑创作整合思维方法及其应用

本文针对建筑创作思维方法进行研究 ,提出了研究整合思维方法的目的、意义以及功能 ,论述了以“真、善、美”作为建筑创作的追求目标和应用整合思维方法进行建筑创作应遵循的基本原则     

逆作法在燕山立交桥施工中的应用

本文通过对桥梁实例施工步骤的概略介绍,重点突出了逆作法施工工艺的特点、施工中要注意事项及与常规施工方案的比较。     

压力实时监测法在管道泄漏检测中的应用

检测输油管道漏油的方法很多，介绍了通过压力实时监测确定输油管道漏油点方法，以及实际应用情况。实践证明，通过压力实时监视确定输油管道漏油点的方法在实际输油运行中是切实可行的。     

大型原油储罐的有限元强度分析

采用有限元分析方法对12.5×104m3大型外浮顶式原油储罐在水压试验时的工况进行了分析,得到了储罐各部位的应力分布.借鉴压力容器分析设计标准进行了应力评定,结果表明,储罐在最高液位下可以安全运行.     

棉花混选-混交育种体系遗传改良效应研究——Ⅰ.主要育种目标性状的响应

研究了陆地棉主要性状对混选—混交育种体系的响应。两轮群体提高了产量、早熟性和降低了麦克隆值的平均数;扩大了纤维品质的变幅;增加了高产株率,但对改进抗枯黄萎病性不明显。一轮群体的效果低于二轮。两次混交扩大了产量和纤维品质的变幅,增加了正末端的个体频率。一次混交的作用不及两次。早代混选相对缩小了群体变幅。一次混交后再经两代开放授粉和对一轮群体再混选,均表现出有益的反响。     

针阀调节式液体射流泵的试验研究

介绍了多种不同结构参数的针阀调节式液体射流泵的试验结果，分析了结构参对泵性能的影响，推荐了合理的结构型式及参数，提出了计算泵性能的经验公式。     

卷边板件屈曲分析的半能量法

A semi-energy method to analyse the buckling behaviour of edge-stiffened plates under combined compression and bending is presented in this paper, One unloaded edge of the plate is restrained elastically against rotation and the other is stiffened by a st     

两端不等弯矩作用下薄壁梁柱的弯扭屈曲

本文采用Ｒａｙｌｅｉｇｈ－Ｒｉｔｚ法求解两端不等弯矩作用下单轴对称开口薄壁截面梁柱弯扭屈曲临界荷载，分析中考虑了三种常见的边界条件以及屈曲前变形的影响，将本文弯扭屈由临界荷载理论值与试验值比较，吻合较好。